are for future improvements and expansion of this system. Pull up the built-in antenna on the top left of the unit when
additional range is required. Push the antenna in for storage in a pocket or purse. The transceiver uses a standard
AAA Alkaline Cell battery that can easily be replaced by removing the access cover on the back of the unit. Battery life
will vary depending on usage. (4-5 months on average)
ARMING:
Press the (I) button on the transceiver to arm the system. The LCD Display will show “ARM” and “LOCK” icons while
emitting a single beep. At the vehicle, the siren will chirp once and the lights will flash once. The red LED in the
vehicle will start flashing. The system will arm, lock the doors, and the starter will be disabled (Optional).
OPERATION
DISARMING:
Press the (I) button on the transceiver. The LCD Display will show “DISARM” and “UNLOCK” icons while emitting (2)
beeps. At the vehicle, the siren will chirp (2) times and the lights will flash (2) times. The red LED in the vehicle will
turn off. The system will disarm, unlock the doors, and the interior dome light will turn on if these optional features are
installed.
SILENT ARM/DISARM: (Programmable)
The system can programmed to ARM and DISARM silently without Siren Chirps. See programming Option #4. Note:
When programmed for silent ARM/DISARM, the Remote Start confirmation chirps will no longer be heard.
TRIGGERING THE ALARM:
After a short 5 second Arming delay (to allow vehicle/electronics to settle), the system becomes fully armed.
INTRUSION:
If there is an intrusion (door/hood/trunk opening) the alarm will sound with siren, followed 8 seconds later with
alternating light flash / horn honk (optional) for 45 seconds. The 8-second delay before flashing lights/honk is to
allow the control module to transmit signals to the pager/remote. The remote will emit an audible alert and the LCD
Display will show a Trunk or Door Opening icon along with audible beeps.
SHOCK/IMPACT:
A hard impact or shock to the vehicle body will trigger the shock sensor and trip the alarm system as listed above.
The LCD will Display Hammer and Glass-Break icons. This may or may not mean that there is actually glass
breaking on the vehicle, but it is a reminder to you that a hard impact was detected.
ALARM PRE-WARNING:
If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 5 quick siren chirps and
1 light flash. The transceiver will emit an audible alert and the LCD Display will show a Hammer icon. To adjust the
shock sensor, turn its control knob to increase sensitivity or decrease sensitivity.
PANIC FEATURE:
