I
II
III
CALL
V
ANTENNA
LCD
PANEL
PAGE/
CALL
SIREN
LOW
BATT
CAR
ICON
ENGINE
BUTTONS 1,2,3
RUN
FM
Two-way
LED
REMOTE START ENGINE OPTIONS
ENGINE TYPE: GAS or DIESEL
Set this switch to select the proper vehicle fuel type. Selecting Diesel delays starter activation about 10 seconds to
allow warming of glow plugs.
TACH/TACHLESS or VACUUM MODE:
For Tach/Tachless Mode
, set Dip Switch #2 ON. For
Vacuum Mode,
set Dip Switch #2 OFF. When this switch is set
to the on position, the unit will monitor the vehicle’s engine according to the setting of Dip Switch #4 below. When in
Vacuum mode, the unit will monitor the Engine using a vacuum switch (not included) and the Yellow Wire.
CRANK TIME:
This feature controls the length of time the starter stays engaged. If the default (0.8 seconds) is not long enough to
start the engine, change the setting to1.25 seconds. These are the only two cranking times. This unit does not use
engine pulses to determine cranking time. Cranking time are preset values only.
This system may not be
compatible with Hard Starting, Out-of-Tune, or Older Vehicles
that require longer cranking times.
TACHLESS or ENGINE MONITOR:
When switch #4 is on, the system is in the Tachless mode and it is not
necessary to connect the gray Engine Monitor wire. When switch #4
is off, the unit monitors engine RPM/Pulses through the Gray wire.
The wire must be connected to a valid source when #4 is in the OFF
position.
OPERATION
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send commands to and
receive information from the 2005FM Alarm system. The Control
Module transmits High Frequency FM signals to the pager for various
alarm functions up to 1 mile away. Range will vary depending on
location, terrain, and RF noise interference. This system is not
guaranteed to page you if you are behind concrete walls,
underground, in a large structure, or an area with high electronic
interference. Handle the pager/remote with care as the LCD display
and/or the electronics may be damaged if abused. Some icons and
areas of the LCD panel are not used or do not animate. These areas
