1. This unit will remote start whether the alarm is on or off. Starting the engine will not trigger the alarm system if it
is in the armed mode when performing a remote start.
2. The vehicle will still be protected when armed/remote started. If a door/hood/trunk is opened, the alarm will
trigger and the engine will shut down automatically.
3. Quickly pressing button 3 will reset any active message icons on the LCD display.
4. If the alarm is triggered by opening the hood, the LCD Display will show and page as a trunk violation. The LCD
remote does not have a separate Hood-Opening Icon.
5. The control module may not respond to multiple commands. You must allow up to 8 seconds between functions
because the unit is sending/paging information to remote/pager.
6. Valet mode inhibits the alarm, remote start, and in-car page/call features.
TRANSCEIVER REMOTE CONTROL PROGRAMMING
The supplied 2-Way Pager/Remote-Transceiver(s) is programmed from the factory to operate the system. In
the event you need to add another transmitter, or reprogram any transmitter to the system, follow the procedure
below. ALL TRANSMITTER CODES MUST BE LEARNED DURING ONE PROGRAMMING SESSION.
NOTE: The Unit will learn a total of (2) Pager/Remote-Transceivers only
1. Turn ignition on and off 3 times within 5 seconds leaving it on the 3
rd
time. (on/off, on/off, on) A single siren
chirp should sound if this was performed correctly.
2. Press the override/program button for approx. 5 seconds until 5 siren chirps are heard.
3. Press the (I) button on the transceiver. You should hear a single siren chirp when the code is accepted, then
and press button (I) for an additional transceiver if necessary.
4. Turn the ignition off and wait a few seconds before trying the one or both transceivers.
DIAGRAM:
