Crestron
TPMC-9L
Isys
®
9” Wall Mount Touch Screen
TPMC-9L Cutout Dimensions (4511860, 2 of 2)
1 in
(25 mm)
3/16 in
(4 mm)
6 13/16 in
(172 mm)
TEMPLATE – OV40110
FOR TPMC-9L MOUNTING CLIPS ONLY
2 OF 2
CUT ALONG
THIS EDGE
EDGE OF MOUNTING PLATE
EDG
E
O
F
M
O
U
N
TIN
G
PL
A
T
E
12 in
(305 mm)
3 5/16 in
(84 mm)
15/16 in
(23 mm)
10 1/16 in
(255 mm)
9 in
(229 mm)
7 1/16 in
(179 mm)
7 1/4 in
(183 mm)
1. Locate an area on the wall that is free of miscellaneous wiring and studs.
2. Make a small hole near the middle of the designated site, and verify that the
location is suitable.
3. Using masking tape (or equivalent), fasten the template to the wall; verify
that the template is level, and trace the opening shape on the wall.
4. Remove the template, and then cut out and remove the traced shape to
produce the required opening.
NOTE
: Before inserting the TPMC-9L in the mounting hole, ensure that all required
cables have been installed in the wall.
5. Install the four supplied #6-AB x 2-1/2” screws and mounting clips as
shown in the following diagram (two on the top and two on the bottom).
a. Insert the screws through the touch screen flange and then through the
larger hole in the mounting clip.
b. Thread the screws through the smaller hole in the mounting clips and
tighten the screws only enough that the mounting clips are brought
flush with the rear of the touch screen flange. Do not compress the
mounting clips at this time.
Operations & Installation Guide – DOC. 7030B
Isys
®
9” Wall Mount Touch Screen: TPMC-9L
•
29
