Crestron
Lighting
Control
System
Wall Dimmers
The CLW-DIM is a stand-alone wall box dimmer that can also act as a Cresnet
device that reports to a Crestron control processor. The CLW-DIM has four preset
lighting levels that can be adjusted (refer to note below). The CLW-DIM also
includes two isolated, non-polarized Cresnet wires (plus a ground wire) for
connecting to the Cresnet network over a twisted pair wire with shield.
NOTE:
The four preset levels are noted as Button 1-High, Button 1-Low, Button
Preset 2, and Button Preset 3. Preset “Button 1-High” is usually used for turning
lights on to full brightness while preset “Button 1-Low” is usually used for turning
the lights off. Although “1-High” and “1-Low” are usually used for “On” and “Off”
respectively, the light level for each preset can be customized by the user. Refer to
the CLW-DIM, DIMS, & SLVD Operation Guide (Doc. 5995) for more information
on installation and customizing light levels.
The CLW-DIM features a three-position mode selection switch. In the absence of
Cresnet communications, the dimmer can still be used to control lighting.
The CLW-DIMS is similar to the CLW-DIM with the added capability of working
with a slave unit
The CLW-SLVD is a slave unit that when used in conjunction with the CLW-DIMS
acts as an additional dimmer control point in a multi-dimmer / single circuit
application. It does not connect to a Cresnet system and cannot be used without a
CLW-DIMS. The CLW-SLVD does not have a mode selection switch and is not
programmable. It emulates the operation of the CLW-DIMS to which it is connected.
The CLW-DIM, CLW-DIMS, and CLW-SLVD are available in white (designated by
part numbers ending in “W”), almond (designated by part numbers ending in “A”,
and black (designated by part numbers ending in “B”). Each dimmer can be covered
with a decorative faceplate (not supplied).
The CLW-DIM, CLW-DIMS, and CLW-SLVD mount in a standard wallbox and are
covered using a decorator-style faceplate (not included).
CLW-DIM, CLW-DIMS, & CLS-SLVD Specifications
SPECIFICATION DETAILS
Power Requirements
Line Power (120 VAC, 60 Hz)
Load Type
Incandescent, Tungsten-Halogen, Magnetic Low Voltage
Load Ratings
Incandescent/Tungsten Halogen
1000 W (800 W)
Magnetic Low Voltage
1000 VA / 750 W (800 VA / 600 W)
Operating Temperature and
Humidity
32°F to 104°F (0°C to 40°C)
10 to 90% Relative Humidity (Non-Condensing)
NOTE:
VA ratings are for input power to the transformer. If you do not know the
input power requirement of the transformer, use the bulb’s wattage rating to
determine proper rating.
NOTE:
Operating temperature affects load ratings. Refer to the Load Rating
specification in the table above for specific operating temperatures. Ratings are given
for 32°F to 86°F (0°C to 30°C) and 32°F to 104°F (0°C to 40°C) operation. Ratings
for 32°F to 104°F (0°C to 40°C) are in parentheses.
Design Guide – DOC. 5999A
Lighting Control System Design
•
17
Summary of Contents for Lighting Control System
Page 1: ...Crestron Lighting Control System Design Guide ...
Page 4: ......
