PN 12071 R122210
27
ASSEMBLY
4.17 MANIFOLD TILT
Avoid crushing injury or death from fall of raised reel.
Before working on or under a raised reel, place all con-
trols in neutral or off, stop combine engine, set parking
brake, remove ignition key, wait for all moving parts to
stop and set cylinder stops on both sides of reel before
servicing, adjusting, repairing, or unplugging.
WARNING
Make sure the reel can be rotated by hand before at-
taching the actuator.
NOTE
Figure 32: Manifold tilt
1. Slide the pivot clamp assembly over the LH end of
the manifold, and position it next to the reel support
weldment (Figure 32). Do not tighten the clamp at this
time.
2. Attach the base end of the electric actuator to the clevis
on the reel support assembly with a 1/2” x 2-1/2” bolt
and locknut.
3. Extend the actuator two inches.
4. Bolt the actuator piston to the clevis on the pivot clamp
assembly with a 1/2” x 2-1/2” bolt and locknut.
5. Rotate the manifold so the line of sight along the air
tubes is directed just behind the cutterbar (Section 5.2)
6. Tighten the pivot clamp assembly on the manifold.
7. Slide the tube cap onto the LH end of the manifold.
8. Secure the tube cap with an 8-3/8” t-bolt clamp.
4.16 REEL TO HEADER INSTALLATION
Avoid crushing injury or death from fall of raised reel.
Before working on or under a raised reel, place all con-
trols in neutral or off, stop combine engine, set parking
brake, remove ignition key, wait for all moving parts to
stop and set cylinder stops on both sides of reel before
servicing, adjusting, repairing, or unplugging.
WARNING
Bolt half-clamps from the bottom up so the nuts are
on top.
NOTE
1. Set the assembled reel into the half clamps on reel
support assemblies, so the brace clamps are inside
of the reel support assemblies (Figure 31).
2. Center the reel between the reel arms.
3. Bolt the half clamps over the manifold and secure with
3/8” carriage bolts and nuts.
4. Replace the OEM reel drive hydraulic hoses with the
provided hoses.
5. Install the hydraulic hoses on the reel drive hydraulic
motor adapters.
Figure 31: Reel to header installation