![background image](http://html1.mh-extra.com/html/crary/air-reel/air-reel_owners-manual_2679348035.webp)
PN 12071 R122210
31
ASSEMBLY
4.20 OPTIONAL EQUIPMENT
4.20.1 AUXILIARY REEL TINE KIT
The auxiliary reel tine kit is recommended for crops that do
not feed well at the ends of the header.
1. Remove one 1/2” X 1-1/2” hex bolt, two 1/2” flat wash-
ers, one pivot strap bushing and one 1/2” center locknut
(Figure 36).
2. Assemble the auxiliary reel tine assembly with two steel
machine bushings as shown in Figure 37.
Place all controls in neutral or off, stop combine engine,
set parking brake, remove ignition key, wait for all mov-
ing parts to stop, then properly block machine before
servicing, adjusting, repairing, or unplugging.
WARNING
Make sure the pitch of the auxiliary reel tines line up
with the existing reel tines.
NOTE
3. Rotate the auxiliary reel tine assembly until the square
end sets into the square hole of the pivot strap.
4. Insert the 3/8” X 2-1/2” carriage bolt through the square
hole of the auxiliary reel tine assembly and fasten the
3/8” flat washer and 3/8” center locknut.
5. Tighten the 3/8” center locknut to 30 ft-lbs.
6. Repeat Steps 1 - 5 for each auxiliary reel tine assembly
being installed.
Figure 37: Assemble auxiliary reel tine kit
1/2" X 2-1/2"
BUTTON HEAD BOLT
PIVOT STRAP
BUSHING
1/2” FLAT WASHER
1/2" CENTER
LOCKNUT
1/2” FLAT WASHER
Figure 36: Loosen and remove hardware and bushing
3/8" X 2-1/2"
CARRIAGE BOLT
AUXILLIARY REEL TINE ASSEMBLY
(RIGHT HAND SHOWN)
7/8" MACHINED
BUSHING
7/8" MACHINED
BUSHING
PIVOT
STRAP
3/8" FLAT WASHER
3/8" CENTER
LOCKNUT
SQUARE END