Frozen Gourmet Setup and Operators’ Guide
4550001
11
.
1.
Replacing a Motor With a Spiral Bearing
REMOVING A MOTOR:
a.
Disconnect the harness from the motor. See CONNECTING AND DISCON-
NECTING A MOTOR HARNESS, below.
b.
Remove the spiral. See REMOVING AND INSTALLING SPIRALS (page
14).
c.
Remove the spiral coupler. See REMOVING A SPIRAL COUPLER (page 15).
d.
Remove the motor. See REMOVING AND INSTALLING A SPIRAL
MOTOR (page 16).
INSTALLING A SPIRAL BEARING:
e.
Put the gear into position if required in this set-up as shown. See INSTALLING
A GEAR (page 17).
Install the spiral coupler. See INSTALLING A SPIRAL COUPLER (page 18).
Changing Tray Configurations
SPIRAL
BEARING
GEAR
SPIRAL
COUPLER
BACKWALL
OF TRAY
˜
2.
Connecting and Disconnecting a Motor Harness
To avoid breaking the motor circuit board,
hold the header on the circuit board when-
ever connecting or disconnecting a motor
harness.
DISCONNECTING A MOTOR HARNESS:
a.
Pull the harness connector away from the circuit
board as shown.
b.
Tuck the unused part of the harness out of the way
in the trough at the back of the tray.
CONNECTING A MOTOR HARNESS:
c.
Locate the harness connector for the appropriate tray position.
Push the harness connector over the header pins on the motor circuit board as shown.
