Frozen Gourmet Setup and Operators’ Guide
4550001
33
4.
Spiral Indexing Procedure (Two Spirals, One Or Two Motors)
The spiral indexing procedures involve rotating spirals one position at a time until the
product vends properly.
a.
Home all the motors (see the Programming Guide).
b.
Remove the left hand spiral of the affected pair.
c.
Is the coupler in the proper position?
NO - Move the coupler to the position as shown in INSTALLING A SPIRAL
COUPLER (page 18). Go to step d.
YES - Move the left coupler to the next counterclockwise position. Go to step
d.
d.
Replace the left hand spiral.
e.
Remove the right hand spiral, spiral coupler, and gear (if used) of the affected
pair as a unit.
f.
Rotate this unit until the right hand spiral mirrors the position of the left hand
spiral.
g.
Replace the right hand spiral, spiral coupler, and gear (if used).
h.
Perform a test vend (see page 31).
i.
Did the product hang up?
NO - You’re finished. Continue to test vend the remaining selections until
everything works right.
YES - Go to step j.
j.
Did you previously move the left hand coupler to the next counterclockwise
position?
NO - Remove the left hand spiral of the affected pair. Turn the left spiral cou-
pler to the next counterclockwise position. Return to step 4.
YES - Return to step b in the operational readiness check (see page 31) and try
another procedure. Do not move the coupler again.
5.
Testing the Bill Validator
a.
Insert a $1 bill into the validator.
b.
Push the coin return button.
THE BILL VALIDATOR IS IN THE ESCROW MODE - No money is
returned - you must make a selection in order to receive any change. Go to step
c.
THE BILL VALIDATOR IS NOT IN THE ESCROW MODE - You should
receive four quarters in change. Go to step c.
c.
Make a selection. the correct selection should be vended and correct change
should be returned.