Page
24
of
52
SLIDE/PUSHER ASSEMBLY
All Slide/Pusher assemblies should be cleaned periodically using warm water and any mild general-purpose
non-abrasive cleaner. After drying, the Slide Assembly needs to have a coat of approved Food Grade Silicone
based Release Agent from ECO-Lab/Kay Chemicals applied. Care should be taken to ensure debris does not
enter the gear box assemblies.
DO NOT USE SOLVENTS OR ABRASIVE MATERIALS TO CLEAN ANY PORTION
OF THE TRAY.
CABINET
Wash the Cabinet with a good detergent or soap mixed in warm water. Wax the Vender often with a good
grade of automobile wax. Any corrosion inside the Vender should be removed with fine steel wool and the
area should be painted with white paint. Repair any scratches on painted surfaces to prevent corrosion.
MOLDED EVAPORATOR BOX, DRAIN TUBE, CONDENSATE PAN AND CONDENSATE PAN SOAKERS
To prevent mold and mildew growth, and to avoid personal injury or property damage, the
Condensate Pan and Drain Tube must be properly aligned and clear of debris. Ensure nothing
obstructs the Drain Tube to prevent the flow of condensate to the Condensate Pan and
Condensate Pan Soakers. Periodically inspect the Molded Evaporator Box, Condensate Pan,
Drain Tube, and Condensate Pan Soakers for alignment and the presence of dirt, debris, mold,
and mildew. Clean as needed. Replace Condensate Pan Soakers as needed.
WARNING
THE COMPRESSOR ELECTRICAL CIRCUIT IS ALWAYS LIVE WHEN THE PLUG IS CONNECTED TO AN
ELECTRICAL OUTLET
.
REFRIGERATION CONDENSER
Clean the Condenser periodically of dirt or lint build-up. Remove the Condenser clean-out cover by turning
Counter-clockwise, this provides access to the Condenser surface. Remove build up with a brush or vacuum,
or blow the dirt out of the Condenser with compressed air and approved safety nozzle. Replace the Condenser
cover by turning clockwise until it stops. Confirm the sealing gasket on the cover is properly seated to prevent
air infiltration. Ensure nothing obstructs air intake at the bottom of the Machine and nothing obstructs air
exhaust at the rear of the Cabinet.
COIN ACCEPTOR, BILL ACCEPTOR AND CASHLESS DEVICES
Follow the Coin Acceptor, Bill Acceptor and Cashless Device Manufacturer’s instructions.
LUBRICATING THE VENDER
The Vender Refrigeration System does not require any field lubrication. The hermetic Refrigeration System
and Fan Motors are manufactured with lifetime lubrication.
Summary of Contents for 3800-4
Page 1: ......
Page 2: ...Page 2 of 52 ...
