Page
8
of
52
ELECTRICAL REQUIREMENTS
Refer to the Machine serial number plate to determine the correct voltage and frequency. In the US and Canada
this is 120Vac, 60Hz, 1P. In Europe, Australia, and other export countries, this is 220/230/240Vac, 50Hz, 1P
depending upon your country voltage. The serial plate also specifies the ampere rating of the Machine. This
Machine must be plugged into a properly rated receptacle with its own circuit protection (fuse or circuit breaker).
Equipment Nominal Power Requirements -
120V / 10.2 A = *1224W (1.224kw)
220V / 5.8 A = *1276W (1.276kw)
240V / 5.8 A = *1392W (1.392kw)
*Note: Watts = V X A
POWER SUPPLY CORD and GROUNDING REQUIREMENTS
In accordance with the National Electrical Code and Underwriters Laboratories Inc., Domestic Vending Machines
are equipped with a three-wire Power Supply Cord and Ground Fault Circuit Interrupter (GFCI). The GFCI device
is provided as part of the Power Supply Cord and is either incorporated directly into the plug or mounted on the
cord adjacent to the plug.
WARNING
•
The
GFCI
protects against current leakage caused by ground faults. The GFCI is not
designed to protect against over current or short circuits.
•
DO NOT
use the TEST and RESET buttons on the GFCI as an ON/OFF switch.
•
The Vending Machine supply cord
MUST
be plugged directly into a properly
grounded, 3 wire receptacle that is properly protected by a fuse or circuit breaker. If
the receptacle will not accept the power cord plug, it must be replaced with a
properly grounded, 3 wire receptacle in accordance with the National Electrical Code
and Local Codes and Ordinances. The work should be done by a qualified electrician.
•
DO NOT USE A 3 WIRE TO 2 WIRE ADAPTOR.
DO NOT
REMOVE THE GROUND PIN ON THE PLUG OR IN ANY WAY BYPASS, MODIFY,
DEFEAT, OR DESTROY THE GROUNDING SYSTEM OF THE VENDING MACHINE.
DO NOT USE WITH AN EXTENSION CORD!
DO NOT REMOVE THE WARNING TAG ATTACHED TO THE POWER SUPPLY CORD.
The GFCI must be tested frequently and before each use in accordance with the instructions provided on the
GFCI device.
IF THE GFCI DOES NOT PASS THE TEST, DO NOT USE THE MACHINE
. Unplug the supply cord from
the receptacle and call the Crane Merchandising Systems Technical Support Group for assistance at 1-803-266-
5001. It is recommended that the Machine be located so that the GFCI device will be accessible after the
Machine is installed. After installation, visually inspect the GFCI and power supply cord to be sure it is not
crushed, pinched, or stretched. Protect the power supply cord during transportation and use. Periodically
inspect the power supply cord for damage. If the cord or plug is worn or damaged, it must be replaced with a
power supply cord of the same type, size and specification as originally provided with the Machine.
DO
NOT USE THE VENDING MACHINE UNTIL THE WORN OR DAMAGED CORD IS REPLACED.
Summary of Contents for 3800-4
Page 1: ......
Page 2: ...Page 2 of 52 ...
