Page
20
of
52
Display will change to show which selections are assigned to this block. Press “
” Key and Display will show
“Enter Selection”. Press the Keys of each selection you wish to disable followed by “
” Key and Display will show
“Disabled Continue?
= Yes CLR = No”. Note: If you press a tray letter (i.e. A) followed by the “
” Key that entire
tray will be set to be disabled. Once you have selected all settings and the Display shows “Disabled Continue? Or
Enabled Continued?
Note: Display must show Display Enabled for the selection to shut down.
“
= Yes, CLR =
No”, press the “CLR” to return to “SET NOT AVAIL TIME”. Press “CLR” again to return to “SETUP MODE 1”. Once
completed go to Test Mode, Not Available Mode (Key 3) and turn on Not Available Mode.
TUBE FILL/DISPENSE
- Press Key “1”
Allows the service technician to inventory currency in the Coin Mechanism escrow tubes and “Teach” the VMC
how many coins of each denomination are in that inventory. This allows for the maximum number of dollar bills
to be accepted prior to enabling the “USE EXACT CHANGE” function. This also provides for exact cash
accountability in the audit functions. This function can also be used as a diagnostic tool to insure the Coin
Mechanism is responding properly. Press the number “1” Key and the Display will read ‘TUBEFILL/DISPENSE”.
Press the “
” Key and the Display will show the lowest denomination accepted and the number of these coins
inventoried. Press the letter “A” Key to scroll through the denominations available. With a given denomination
Displayed, an inserted coin of this denomination via the coin chute will increase the inventory shown. Note: When
you insert any denomination the Display will change to show the denomination inserted. To dispense: while in
the tube fill/dispense mode go to the Coin Mechanism and press the Coin Mech. dispense button(s) for the tube
you wish to dispense or press the “
” Key and the denomination Displayed will be dispensed to the Coin Return
Cup and the inventory will be decreased. Press the “
” Key again to stop the coins from being dispensed. Press
the “CLR” Key to return to “TUBE FILL/DISPENSE”. Press the “CLR” Key to return to “TEST MODE” or press the “A”
Key to advance to the next menu item below.
TEST VEND - Press Key “9”
Allows the service technician to test vend any item. The Service Door must be closed or opened all the way so the
Discharge Door does not hit the Delivery Port during the test vend process. You will need to catch the product if
you test with the Service Door open. Press the number “9” Key and the Display will read “TEST VEND”.
IMPORTANT: The left Door Switch (in the Door Switch Bracket Assembly) must be activated for this test to work.
Press the “
” Key and the Display will read “ENTER SELECTION”, you must close and lock the Service Door at this
point if you wish to test with the Door closed. Select the item/column to be tested by pressing the corresponding
Keys to test vend (i.e. A6), then press the “
” Key to start the test vend, and the corresponding vend cycle will
occur. Press the “CLR” Key to return to “TEST VEND”. Press the “CLR” Key to return to “TEST MODE” or press the
“A” Key to advance to the next menu item.
Summary of Contents for 3800-4
Page 1: ......
Page 2: ...Page 2 of 52 ...
