7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
hanging
bracket
canopy
page 9
screw
screw
canopy cover
6. Wiring. (cont.)
[
PLEASE NOTE
: Wall and/or handheld remote
control must be used for fan to operate.
If you do
not
wish to use the wall control, please proceed to
Section 7 below to continue with fan installation.
]
To install wall control
, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided
as shown in diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT
: Wall control will not function unless
battery is installed.
WARNING
: Battery is to be inserted with the
correct polarity.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate
(included) to wall control using 2 screws provided
with the wall control.
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
12V battery
plate
I
II
IV
VI
I
I
I
I
I
I
V
