page 6
hanging bracket
mounting plate
mounting plate nuts
and washers
5. Fan Assembly.
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
diagram 2
diagram 3
diagram 1
electrical wiring
safety cable
pin
clip
downrod
canopy
canopy cover
yoke
cover
motor
housing
support cable anchor
yoke plate screws
and washers
yoke set screw
and nut
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [
Refer to
diagram 1
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [
Refer to
diagram 1
.
]
If you wish to install fan in a covered patio
,
remove 6 screws and washers from yoke plate at
top of motor housing and set aside. Align holes in
support cable anchor with holes in yoke plate and
re-insert screws that were previously removed.
Tighten all screws securely. [
Refer to
diagram 2
.
]
Remove 2 set screws from the top of downrod and
save for later use. Slide downrod into canopy,
canopy cover and yoke cover. [
Refer to
diagram 3
.
]
(
Note
: Canopy cover must be turned with smooth
side
toward
the motor housing.) If using support
cable anchor, align openings on botton of yoke
cover with anchor holes on support cable anchor.
["Fan Assembly" continued on next page.]
4. Mounting Plate & Hanging Bracket Installation. (cont.)
Remove preassembled nuts and washers from
mounting plate. Attach hanging bracket to
mounting plate by replacing nuts and washers on
mounting plate. Arrange electrical wiring around
the back of the hanging bracket and away from
the hanging bracket opening.
WARNING
: If outlet box is not supported by a wood
ceiling joist,
YOU MUST MAKE SURE
outlet box is
able to support the weight of the fan.
set
screw
set
screw
