page 15
14. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to
the ON position. Test light and dimmer function and then
test fan speeds. Next, locate handheld remote control. Test
fan speeds with the different fan speed buttons (
I - VI
) on
handheld remote control. Test the light ON/OFF function
by pressing the button; test the dimmer function by
pressing the button and holding it down for up to
5 seconds. If the wall and/or remote control operates all of
the functions of the fan, battery/batteries has/have been
installed correctly. If the wall and/or remote controls do
(does) not operate all of the fan functions, refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Fan
must
be on LOW
before
setting the fan in reverse.
Use button to recirculate air depending on the
season. A ceiling fan will allow you to raise your
thermostat setting in summer and lower your thermostat
setting in winter without feeling a difference in your
comfort.
NOTE
: If the wall control/handheld remote control
interferes with other appliances, activate a new code on
the wall control/ handheld remote control by
turning the
power off first
. Go back to the instructions for the SET
button in Section 11 (page 13).
IMPORTANT
: Handheld remote control and wall control
must be synchronized with fan in order to properly
function.
NOTE
: When operating the fan in a covered patio location,
it is possible for high wind gusts to cause the fan to stop
briefly. It will then emit a warning beep for 60 seconds and
restart at the same setting. If you wish to restart the fan
sooner, you may push the SPEED button during the
60-second warning beep.
I
II
IV
VI
III
V
I
OFF
ON
II
III IV
V
VI
