Crafco SUPER SHOT 125, Parts Manual

Page: 82 / 230

Super Shot 125 Diesel Melter Part Manual
Chapter 8 Troubleshooting (43600, 43800 and 45500)
©2017 by Crafco, Inc. All Rights Reserved………………...……………Troubleshooting (43600, 43800, and 45500) 8-14
Step Possible Cause If . . .
4 Check for 12Vdc at red wire labeled Red Lid
and pink wire labeled Pink-2 on terminal
block left side upper corner and a nearby
ground source (black wire).
•
Yes on both, check for loose connections or
broken wires between lid switch and
terminal block.
•
No on Red Lid and Yes on Pink-2, ensure
both wires are securely installed in the
terminal block, and that the yellow jumper
bar is securely installed between the two
terminal blocks.
•
No, go to Step 4a.
4a Is there 12Vdc between the Material
PAKSTAT terminal #2 pink wire and terminal
#8 black ground wire?
(Refer to Fig. 8-5 Mixer Schematic .)
•
Yes, check for loose connections or broken
wires between PAKSTAT terminal #2 and
terminal block.
•
No, go to Step 4b.
4b Is there 12Vdc between the Material
PAKSTAT terminal #1 orange wire and
terminal #8 black ground wire?
•
Yes, replace the Material PAKSTAT.
•
No, go to Step 4c.
4c Is there 12Vdc between orange wire labeled
ORN-1, terminal #9 and terminal #8 ground
source (black wire)?
•
Yes, check for loose connections or broken
wires between terminals #8 and #1.
•
No, go to Step 5.
5 Is there 12Vdc at orange wire labeled ORN-1
and ORN-2 on the upper terminal block?
•
Yes on both, check for loose connections or
broken wires between terminal block and
material PAKSTAT.
•
Yes on ORN-2 and No on ORN-1 replace
terminal block.
•
No on both, go to Step 6.
6 Is there 12Vdc between orange wire labeled
ORN-2 terminal #3 and terminal #5 black
ground of hot oil PAKSTAT?
•
Yes, check for loose connections or broken
wires between terminal #3 and terminal
block.
•
No, go to Step 7.
Table 8-16 Mixer Electrical Troubleshooting (continued)