Super Shot 125 Diesel Melter Part Manual
Chapter 8 Troubleshooting (43600, 43800 and 45500)
©2017 by Crafco, Inc. All Rights Reserved………………...……………Troubleshooting (43600, 43800, and 45500) 8-11
Sealant is Heating Slowly
8.1.9
Table 8-13 Sealant is Heating Slowly
Step
Sealant is Heating Slowly
1
With the material level half or less, open the loading lid and inspect the inside edge of the
material tank. Check if there is a buildup of old, dried out and hardened material along the top
half of the material tank.
2
If this is the case you will need to drain out (use up) the rest of the material inside the tank.
When the tank is empty, use an air chisel to remove this built up material. Remove as much
as possible all around the tank including the roof of the material tank. Remove all the old
sealant chunks from the bottom of the material tank. This should be done every year or as
conditions require.
3
Check your level of the heat transfer oil, the mark on the dipstick is for 70°F.
4
Check your records of the last service replacement of the heat transfer oil. If it has been
longer than 500 hours, or one year, you need to change your oil.
5
Many of Crafco, Inc. service centers can perform these service steps for you if you cannot.
Call your local service center to find out if they can.
Summary of Contents for SUPER SHOT 125
