Page 8 of 16
v3.1
m
ountIng
InStructIonS
Identify a suitable mounting location for the warning device on a flat wall. If you are installing the
Wirefree version, you can use the built-in coms feature to locate the best location and ensure the there is
communication between the warning device and the control panel module.
It should not be possible to reach the device without the aid of access equipment, where practical it
should be sited under the eaves to give additional protection.
Mark the fixing points on the surface of the selected location using the drill template on the back of the
box. Drill 3 holes using a 5.5mm masonry drill 41mm deep for the enclosed wall plugs, insert the wall
plugs into the holes, fit the top centre screw, enclosed, leaving it protruding by 25mm.
Feed the cable through the cable entry point on the
s
enza
and carefully slot the top fixing point of the
s
enza
over the previously installed screw, rotate the 2 x bottom fixing points, if necessary, to allow the
holes to line up and fix in-place using the enclosed screws.
Please note in order for the tamper protection to function correctly one of the mounting screws is
required to be fitted in the removal from wall mechanism as shown below. Do not over-tighten this
screw
.
If forced removal is attempted this will cause irreversible damage and may need replacing.
X
Use the
template on
back of the Box
