Page 12 of 16
v3.1
W
IrIng
c
onnectIon
g
uIde
Wirefree Version
Fault
Fault
Test
Con-
firmed
Hold-off
Pos +
Siren
Strobe
Tamper
Rtn
Hold-off
Neg -
CPM
Connections
Connect to a
suitable input
within the
control panel
Connect to a
suitable output
within the
control panel
1. Connect Hold-off Neg - 0v to
12v -
2. Connect Hold-off Pos + ve to
12v +
3. Connect Siren to
OP
BELL
4. Connect Strobe to
OP
Strobe
5. Connect Tamper Return to
an input via a 2K2Ω resistor
1. Connect Hold-off Neg - 0v to
D
2. Connect Hold-off Pos + ve to
A
3. Connect Siren to
B
4. Connect Strobe to
S
5. Connect Tamper Return to
C
1. Connect Hold-off Neg - 0v to
12v com
2. Connect Hold-off Pos + ve to
+12v
3. Connect Siren to
BELL
4. Connect Strobe to
STRB
5. Connect Tamper Return via a 2K2Ω resistor to
D1
1. Connect Hold-off Neg - 0v to 0v
2. Connect Hold-off Pos + ve to 12v
3. Connect Siren to Bell
4. Connect Strobe to STB
5. Connect Tamper Return to TR
Texecom
Pyronix
Honeywell
Scantronic
C
A
S
B
D
D1
+12V
STRB BELL
COM
TR
+12V
STB BELL
0v
Input
12V
OP
STRB
OP
BELL
12v-
Connect to a
suitable output
within the
control panel
1. Connect the
CPM
to the control panel as shown in the
‘Senza CPM connections’
below, ensuring that the DIP
switches are set to your requirements. The Green and Red LEDs should flash alternately.
2. Connect the battery in the
WD
. The
CPM
and
WD
should automatically pair. This is indicated by the Green LED on
the
WD
flashing every 2 seconds. If not refer to Installation and operating instructions on
‘How to pair’.
3. During the next 30 minutes the
WD
will be in engineer mode, after which it will automatically leave this mode.
Note: if the tamper is still open the sounder will sound.
4. Whilst the
WD
is in engineer mode the Green LED flashes every 2 seconds to indicate that the
WD
is
communicating with the
CPM
.
5. Using this feature will allow you to select the best position for the
WD
to be installed, if the Green LED stops
flashing it has lost communication with the
CPM
and should be repositioned.
6. The Blue LED on the
WD
flashing every 2 seconds indicates that the tamper is closed.
7. To exit Engineer mode briefly apply a trigger to the Siren input of the
CPM
the Strobe will flash once and the
sounder will chirp.
8. Normal operating mode is indicated by the Green and Blue LEDs on the
WD
flashing alternately every 4 seconds.
Note:- Examples shown below are provided only as a guide, Control panel manufacturers may alter their notation
from time to time and there may be differences to those shown.
