4096-224
CPI SATCOM & Antenna Technologies
1.8M SERIES 1184
15
STEP 14:
STEP 15:
A). Locate the top of the reflector and insert
(2) 5” bolts ( item 13 ) thru top two inner
most holes on face of reflector as shown.
Top of Reflector
[ 13 ]
A). With a person on each side of the
reflector, lift the reflector up.
B). Position the reflector so that the (2) bolts
(step 14) pass thru the two inner holes
in the top cross arm.
C). Loos
ely attach 3/8 ” hardware
(items,14,15,16).
Note:
the reflector is
fully supported at this time.
D). Insert the (2) remaining 5” bolts (item 13)
thru the remaining two holes on top of
reflector.
E). I
nsert the (4) 4.5” bolts (item 12) thru the
four bottom holes in reflector.
F). Secure with (items 14, 15, 16).
G). Using the torque specifications on page 6,
tighten all reflector and mount hardware,
with the exception of the
1 / 2” carriage
bolts (they will be tightened in section III)
Top of Reflector
Cross Arm
( TOP )
Cross Arm
( BOTTOM )
[ 14,15,16 ]
8 places
[ 12
]
Reflector Support Tube
[ 13 ]
