4096-224
CPI SATCOM & Antenna Technologies
1.8M SERIES 1184
13
STEP 9:
STEP 10:
STEP 11:
A). Loosen 1 / 2” nuts on elevation rod
to allow movement of the elevation
block.
B). Slide elevation block down the
elevation rod and position the block in
between the small tabs on the
positioner so that the holes in both
block and tabs are aligned.
Elevation Rod
Elevation Block
1 / 2”
Nuts
A). Secure elevation block to positioner
with 1 / 2” hardware set aside in step 7
Elevation Block
1 / 2” Hardware
Positioner
A). Remove (2) #10 screws and washers
from reflector support tube.
B). Attach elevation marking plate (item 6)
to support tube as shown with spacers
(item 5) and #10 hardware.
Note placement of spacers (item 5).
C). Tighten only until lockwashers are
flattened.
Reflector Support Tube
[ 5 ]
[ 6 ]
Positioner
Asm
# 10
Hardware
