MAINTENANCE MANUAL
YUI
pag. 7 di 16
Ver 01
–
2021-07-09
WARNING
WARNING
WARNING
WARNING
INSTALLATION LOCATION: HOW TO CHOOSE
The installation of the SPA must be carried out in compliance with the safety standard CEI 64-8 / 7 and
subsequent amendments. When choosing the positioning, take into account that the inspection sides
(inspection doors) must always remain accessible for future maintenance. The recommended ambient
temperature for the hot tub must be between -5 ° C + 45 ° C, with a relative humidity of 20 - 80%.
External Installation
The presence of trees or hedges near the tub, with possible loss of debris (eg leaves), could
cause damage to the equipment over time (not covered by warranty) and lead to more expensive
and frequent maintenance. Also evaluate the best position to safeguard one's privacy and respect
for others and the best panoramic or climatic position compatibly with local regulations. An area
exposed to the morning sun guarantees greater well-being for users.
Pay attention to the characteristics of the ground on which the support platform will be built: sandy
and unstable soils or subject to flooding could compromise the stability of the base over time and
therefore the safety conditions of the hot tub itself.
Internal Installation
The evaporation of the water from the hot tub, in the presence of high internal temperatures, can
generate very high humidity levels in the environment: choose an environment with good
ventilation, natural or forced. Alternatively, set up an air treatment system. Damage caused by
humidity is not covered by the warranty.
Pay attention to the dimensions of the hot tub: passages, doors, steps, can be an obstacle to its
transport to the desired place.
If you install the whirlpool tub inside, it should be remembered that the tub must be easily
inspected or moved for any ordinary and extraordinary maintenance operations.
INSTALLATION LOCATION: HOW TO PREPARE
Before creating the support surface, consult the sections of the hydraulic and electrical
connections to correctly position the connections.
The correct positioning of the tub is determined by the support surface. It is not possible to insert
wedges or shims under the hot tub to level the top.
Above ground installation (with lateral panels)
Create a base or floor in reinforced concrete that is flat and suitable for supporting the weight of
the hot tub and its guests. Check the load capacity of the installation site for a weight of 300 kg /
m2.