MAINTENANCE MANUAL
YUI
pag. 14 di 16
Ver 01
–
2021-07-09
CLEANING AND MAINTENANCE FILTER CARTRIDGES *
The filter cartridge must be cleaned regularly, using clean water, with a maximum
frequency of 7 days: this will be increased according to the workload of the tub and
the increase in water temperature.
Clean the surface with neutral soap to degrease the surfaces and rinse until
completely clean.
Do not use brushes or high pressure washing.
It is recommended to replace with a new filter every 3 months, in case of intense use
(SPA ad public use) and 6 months for domestic use. Always replace the complete set.
A clogged filter or series of filters can significantly reduce the life of the electrical
equipment involved in the filtration (pumps, heaters, etc.): the manufacturer declines
all responsibility for damage resulting from this condition.
•
Remove the cartridge protection package (plastic film if present)
•
Remove the floating lid of the skimmer by rotating it before removing it
•
Remove the filter cartridge
•
Wash the cartridge with water and neutral soap or dish detergent and, once rinsed thoroughly, put
it back in its seat
•
Replace the lid on the top of the filter basket
TUB CLEANING
1.
Clean the hot tub with a mild detergent and a soft cloth. Do not clean with
acetone, ammonia solution and organic solvent, otherwise the surface of the tub
may be damaged.
2.
Remove limescale from the bathtub using a mildly acidic detergent such as citric
acid or vinegar, rinsing thoroughly.
3.
Do not rub the chrome parts (avoid contact with solvents)
4.
Cleaning the whirlpool system: pour hot water up to the surface of the nozzles,
add an adequate amount of detergent, start the whirlpool for 5 minutes, stop the
pump and drain the water, then add clean water and start the whirlpool for 3
minutes, stop the pump, drain the water and clean the bathtub with a soft cloth.