MAINTENANCE MANUAL
YUI
pag. 13 di 16
Ver 01
–
2021-07-09
ELECTRICAL PREPARATIONS
The C.P.A. srl are a Made in Italy product, built in compliance with European laws and tested during
production to ensure the safety of the installer and user.
The electrical arrangements and the electrical connection must be carried out by a qualified and licensed
electrician, in compliance with the legislation in force at the time of installation.
WARNING
All electrical setup operations must be performed after disconnecting the power supply from the
power line dedicated to the SPA.
The electrical connection must be::
•
dedicated to the SPA: do not connect other devices to the same line;
•
executed in a fixed and permanent way, without intermediate joints, in compliance with the
regulations of the country of installation;
•
suitable for the current absorption of the tub (see technical characteristics);
•
provided with an effective grounding in accordance with the law;
•
protected against splashes of water, therefore placed in a dedicated room, closed and sheltered
from agents
•
atmospheric;
•
controlled by an omnipolar switch with contact opening of at least 3 mm and one power
•
interruption equal to 60 A (or in any case adequate for the absorption of the tub);
•
controlled by a differential switch not exceeding 30 mA.
The power cable to the control panel must be of the H05 type with three conductors (single-phase 220V)
or 5 conductors (three-phase - 380 V) with sections suitable for the absorption of the whirlpool tub: the
section must be adequate for the absorbed current and distance of the tub from the big picture. In
addition, if the whirlpool tub is installed outdoors, the power cable from the general electrical panel to
the tub must be passed through an underground channel, adequately protected from frost
WARNING
The installation of the SPA must be carried out in compliance with the safety standard CEI 64-8 / 7 and
subsequent amendments.
