Cosen C-620NC, Instruction Manual, Page: 76 / 122

7 ‐ 2
Material and its relation to the cutting rate
Fig. 7.1 Description of Band

Depending on the hardness of the material the cutting rate will increase or decrease. For
example, it takes more time to cut stainless steel than to cut cast iron.

The surface conditions will also affect the cutting rate. If there are places on the surface on
the material which are hard, a slower blade speed will be required or blade damage may
result.

It will be slower to cut tubing than to cut solids, because the blade must enter the material
twice, and because coolant will not follow the blade as well.

Tough or abrasive materials are much harder to cut than their machinability rating would
indicate.

Tooth spacing is determined by the hardness of the material and its thickness in cross
section.

Tooth set prevents the blade from binding in the cut. It may be either a "regular set" (also
called a "raker set" ) or a "wavy set".

The regular or raker set is most common and consists of a pattern of one tooth to the left,
one tooth to the right, and one which is straight, or unset. This type of set is generally used
where the material to be cut is uniform in size and for contour cutting.

Wavy set has groups of teeth set alternately to right and left, forming a wave ‐ like pattern.
This reduces the stress on each individual tooth, making it suitable for cutting thin material
or a variety of materials where blade changing is impractical. Wavy set is often used where
tooth breakage is a problem. This is shown in Fig. 7.2 as follows:
Right
Straight Left
Regular (raker) Set Wavy Set
Fig. 7.2 The Saw Set
Tooth Set
Tooth spacing