Cosen C-620NC, Instruction Manual, Page: 45 / 122

4 ‐ 11
No Item Function Description
Be sure that the guide arm will not bump into the
front vise, set the guide arm width according to the scale on
top of the sliding board.
12
Guide arm to the right Press this icon to move the guide arm to the right.
The saw bow must be above the middle limit switch
AND carbide inserts selection switch must be turned to
unclamped position to move the guide arm.
Be sure that the guide arm will not bump into the
front vise, set the guide arm width according to the scale on
top of the sliding board.
13
Trim cut ON/OFF
This selection button works with the AUTO mode.
When under AUTO mode and before proceeding with your
automatic cutting jobs, select +0 if you wish the first cut to
be “trim cut” i.e. trimming the edge of your material without
the cut being counted into the “finished cuts.”
In the other hand, select +1 if you do not need to trim cut
the material. The first cut will then be counted as the first cut
of your programmed jobs.
After the first cut begins, you may still change your
selection before the saw bow has descended to its lowest
point.
14
Carbide inserts
clamp/unclamp
When under Manual mode, press this button to clamp
carbide inserts. Press again to unclamp.
The carbide inserts will automatically clamp the blade
when the saw blade start button is pressed. This safety
design is incorporated in the program to protect both the
user and the blade during cutting.
15
Wire brush up
Used only when under Manual mode.
Press to test if the wire brush can be raised smoothly.
16
Wire brush down
Used only when under Manual mode.
Press to test if the wire brush can be lowered smoothly.
17
Saw blade up indicator
Indicates that the saw blade is rising.
When activated, the saw blade icon will turn solid white.
18
Saw blade down
indicator
Indicates that a cut is completed and the saw blade is at its
lowest position.
When the blade completes each cut and triggers the lower