Cosen C-620NC, Instruction Manual, Page: 49 / 122

4 ‐ 15
Page 2 – cutting status setup
The operator can setup cutting parameter in this
page(from top to bottom):

Width ‐ Set the material width, during cutting the
system will calculate the cut rate based on the
width of the material.

Height ‐ Set material height so the system can
automatically calculate the cut rate.

Blade speed – Key in the blade speed. Press + or ‐
to fine adjust blade speed.

L Gear –Press this button to switch between low
and high gears for the drive belt.

Start Job – Key in the number of the job you wish
to execute first under automatic mode
.

End Job – Key in the number of the job you wish
to execute last under automatic mode
.

Current blade life in hours

Error message (bottom of page)

Press Home to return to the main control menu.

Press PGUP to go back to the previous setup page.

Press Next to go to the next setup page.

Cut Piece Reset ‐ Reset all Cuts Finished data by
pressing this button for three seconds.
If you start a new set of program without
clearing cutoff data from previous job, the first cut
(trim cut) will be skipped as the second program is
deemed as the succeeding part of the previous
program.

All Reset ‐ Reset all preset cutting data within
Starts Step and Ends Step by pressing this button
for three seconds.

Blade Life Reset ‐ Reset the blade life to zero