Cosasco Checkmate DL, Reference Manual

Page: 35 / 71

CHECKMATE™ DL 27
WARNING!
No Response From RDC
Check Connection
Exit
Press the Exit (F4) key to return to the Con fi guration Options
display. Select RDC (F2) to go to the RDC Con fi guration display
and repeat the above process with the connection properly
established.
If either of the following error messages appears, verify the
Probe Type con fi gured for the RDC/ER-210. RDC – CO
(Corrosometer) and RDC – CA (Corrater) technologies require
different probe con
fi gurations. Refer to the Manually Con fi guring
a Corrosometer or Corrater Probe attached to a RDC/ER-210
section or Probe Con fi guration using a PC and Corrdata Plus
Software section in the Probe Con fi guration chapter for more
details.
Upon successful entry of the ID, the following
RDC Con fi guration display will
appear:
RDC Con fi guration
Set New
Start Mux Probe Exit
Press Start (F1) to con fi gure the RDC/ER-210.
If the connection between the RDC/ER210 and the Checkmate DL
is interrupted, the following display will appear:
WARNING!
No Response From RDC
Check Connection
Exit
Verify the connection by checking the LEMO connector cable
between the Checkmate DL and the RDC/ER-210. Press
Exit (F4)
and retry.
If the RDC/ER-210 was previously programmed, Checkmate DL
will proceed to the following display:
WARNING!
Mate Not Connected
To RDC - CA
Exit
WARNING!
Mate Not Connected
To RDC - CO
Exit