© Corroventa Ltd.
2017.02
8 (15)
Installation
Before use, verify that the machine’s interior is clean and that the air filter is not dirty or clogged. If
necessary, clean the machine’s interior and replace the air filter before the work is initiated.
Always use the power outlet on the WS4 ES machine to supply the turbine or the Kombi machine to
ensure that it is stopped when the pump is activated. If the turbine/Kombi machine does not stop,
the pump will not be able to empty the machine and water will reach turbine or the Kombi machine.
Installation:
1.
Place the machine steadily and leveled to ensure that it does not fall over. The machine must
not be tilted more than 5 degrees in order for it to work properly.
2.
Connect the air hoses. The inlet is connected to the hose/hose system that leads to the
construction. The outlet is connected to the turbine/Kombi machine.
3.
Connect the water hose and lead it to suitable drainage.
4.
Connect the turbine/Kombi machine power cable to the power outlet of the WS4 ES.
Doing so ensure that the turbine/Kombi machine is stopped when the pump is activated,
preventing water from reaching the turbine and also allowing the pump to function as
intended. The built-in pump support elevation heights of up to 3.5 meters.
5.
If using the WS4 ES with a digital ES-family turbine, in addition to the power cable, the WS4
ES can also be connected to the turbine with a system cable. Doing so allows for the turbine
to count the number of times the water separator has been emptied and also to keep track of
when the last cycle was completed. This connection is optional, not necessary. Regardless of
whether this connection is used or not, the turbine power cable shall always be
connected to the WS4 ES.
6.
When installation of the turbine/Kombi machine is finished in accordance with its manual,
connect the machine power cable to grounded, single phase 230VAC, 50Hz power outlet with
maximum 16A fuse. As the machine is normally used in humid environment, the use of
residual-current device / ground fault circuit interrupter is recommended.
7.
Start the system with the On, Start, button. The alarm indicator will give one brief flash as to
indicate that the start-up was successful and no errors were detected. If there is water in the
WS4 ES, it empties this automatically before it powers the turbine/Kombi machine. If no
water is detected, the turbine/Kombi machine is started immediately.
8.
Verify that the air flows through the turbine and the construction are correct so that intended
drying effect is achieved and that the process is not interrupted by overheating
turbine/Kombi machine.
Always use the
power outlet on
the WS4 ES for
Turbine/Kombi
machine!
Summary of Contents for WS4 ES
Page 1: ...WS4 ES WATER SEPARATOR USER MANUAL ...
Page 2: ......
