CorroVenta A15ES, User Manual

Page: 15 / 67

A15ES
© Corroventa Avfuktning AB 2022.05 15 (67)
o
Rain or snow is not drawn in.
o
Wire mesh with mask size of around 10mm is appropriate to prevent objects and
animals from entering while still not causing excessive pressure drop.
o
Is positioned so that the wet air from the machine will not be drawn back into the
machine
– preferably placed at least two meters or more away.
•
Wet air outlets outdoors are made such that:
o
The ducting has a continuous slope outwards so that condensation will be allowed to
exit or, if this is not possible, there is a drainage point made at suitable low point.
o
Wire mesh with mask size of around 10mm is appropriate to prevent objects and
animals from entering while still not causing excessive pressure drop
In the planning, with regards to the machine positioning, also consider that:
To allow for the service hatch to be opened for service and repair, a floor space with a
depth of minimum of 850 mm is to be left free. In open position, the service hatch is
raised vertically and thus the free height is most preferably 1900 mm.
The floor of the free space in front of the machine hatch is preferably of the same
height as that of the floor on which the machine is positioned. The reason is that the
extractable rotor cassette is provided a support to prevent the machine from falling
over due to the shifted centre of gravity. An elevated position of the machine will
prevent the support from reaching the floor and thus the support will no longer
prevent accidents. If an elevated is unavoidable or still preferable, the machine must
be secured to the floor to prevent it from falling over during service and maintenance.
On the rotor cassette, visible when the service hatch is
opened, is a warning label intended to inform and
remind the user about the risk described.
Summary of installation, main points:
1. Position the dehumidifier horizontally and stably so that it does not fall over and cause
damage. Suitably, note the need for free space in front of the service hatch and that elevated
positions are to be avoided as earlier described.
2. Connect required ducting for the respective airflows given the circumstances and observing
the ducting instructions presented earlier.
3. Check that filters, both process and regeneration, are mounted and that these are clean and
intact.
4. Check that service hatch, filter hatches and electronics cabinet are closed and locked.