4-16
Section 4
Correct Craft, Inc.
NOTICE
The “System Indicator Light” is on the right side of the ignition
keypad. The “Ignition Indicator Light” is on the left side of the
ignition keypad.
Programming the Primary User Code
NOTICE
Until a Primary User Code is set, the keyless ignition does not
require the entry of a code to unlock the system or start the engine.
The system operates as follows:
1. Press START to unlock the system.
2. Press it a second time to start the engine.
3. Press STOP to turn off the engine.
4. Press it a second time to lock the system. The system indicator
light should be OFF.
To program the Primary User Code, make sure the system indicator
light is off, then press and release the 1/2 key and the 7/8 key at
the same time to put the system in the Code Programming Mode.
The system indicator light will flash.
Enter a code from two to eight characters and press START. For
verification, re-enter the code and press START again. The system
indicator light should stop flashing and stay ON. If the light does
not stop flashing, press STOP and begin again.
To lock the system, re-enter either the Primary User Code or the
Master Embedded Code and press STOP.
Nautique Ski Sec 4.qxd:Nautique Ski Sec 4.qxd 6/19/07 4:43 AM Page 16
Summary of Contents for 2008 2008 70141
