Cormach GEO 15, Service Manual, Page: 95 / 102

2. if the print resolution value is not available on the page where the print quality is set, you must proceed
with attempts, using the following logical reasoning.
Example : if we have installed an HP Deskjet 3745 printer, and we have set the print quality
as “Fast Normal”, if the following inscription is shown in the file “Printer.ini”:
[Printer.HP Deskjet 3740 Series]
_-3=-3
we must modify and save the numerical description as follows:
[Printer.HP Deskjet 3740 Series]
-3=300
Print a graphic test page. If the graphic image is:
• correct
the setting made for the test is correct and we can leave that setting
[Printer.HP Deskjet 3740 Series]
-3=300
• smaller (half)
the setting made for the test is not correct and we must modify and save the setting as follows
[Printer.HP Deskjet 3740 Series]
-3=600
• bigger (double)
the setting made for the test is not correct and we must modify and save the setting as follows
[Printer.HP Deskjet 3740 Series]
-3=150
In any case, we have removed the underlining symbol (the first character), leaving the rest unaltered, and
we have replaced the number after “=” with the chosen resolution value.
Note: the setting of the file “printer.ini” is made by repeating the entire procedure explained above
(starting from point a) and following the procedure again up to this point).
For every possible configuration item for the print quality (modifying the print quality each time, under
printer properties), a number of lines corresponding to the number of possible settings verified will be
added to the file. As an example, here is the complete final section relating to the HP Deskjet 5652 printer.
[Printer.HP Deskjet 5600 Series]
-1=300
-2=600
-3=600
-4=600
WARNING:
with the settings at the limit (“Maximum dpi”), the printer becomes very slow and the cartridges are
consumed quickly. In addition, some printers give resolution identification codes that are identical. It is
highly important not to give repeated indications in the file
“printer.ini”
Example:
for the HP Deskjet 5652 printer, we have the following condition:
[Printer.HP Deskjet 5600 Series]
_-1=-1 (Fast Draft) 300 dpi
_-2=-2 (Draft) 600 dpi
_-3=-3 (Fast Normal) 600 dpi
_-4=-4 (Normal) 600 dpi
_-4=-4 (Maximum dpi) 1200 dpi
In this case there are two lines with an index of “_ - 4=”
94
GEO 15 Service Manual - Rel. 0 2 0 6 -2016