Cormach GEO 15, Service Manual

Page: 41 / 102

40
Wait for the answer
Good Calibration : Press NO if you want
to continue. Press YES/SI to perform
again this check.
If the answer is Bad Calibration the
problem could be or the camera or the
calibration bar is not stable.
For more information see the
troubleshooting page.
Press NO.
The calibration check is finished.
In this case the Calibration Check is OK.
No further calibration are required.
Report of Calibration Check
LH Bar: Measure of the calibration bar
from the LEFT camera point of view,
during Calibration Check.
RH Bar: Measure of the calibration bar
from the RIGHT camera point of view,
during Calibration Check.
Cameras: Relative positioning of the 2
cameras in the space, measured during
Calibration Check.
Actual: Internal (working) calibration.
NOTE: If Rx, Ry, Rz values of Cameras and
Actual rows are different of more
0.10(degrees), the Calibration Check is
NOT GOOD.
If Rx, Ry, Rz values of Cameras and
Actual rows are different of more
0.10(degrees), the Calibration Check is
NOT GOOD.
If Rx, Ry, Rz values of Cameras and
Actual rows differ less than
0.10(degrees), the Calibration Check is
GOOD.
GEO 15 Service Manual - Rel. 0 2 0 6 -2016
At the end, set again the screen resolution at 800 x 600.