Cormach GEO 15, Service Manual, Page: 84 / 102

83
Plug the main power of the aligner and turn on the
PC. After the boot procedure, the main page of the
wheel aligner software will be shown.
The aligner is working properly.
Now it is necessary to exit to Windows.
Select
to exit to Windows or press "F2" and
Set the screen resolution at 1920 x 1080.Run ServiceWindows.exe
placed on desktop.
The password is “1234”.
Press OK for both messages. The camera codes are
the camera serial numbers. You should see the new
camera serial number.
This message informs the operator that one camera
has been replaced. Clicking on OK the new camera
calibration parameters will be stored in the PC.
Press OK.
enter the password "end".
Click on the SERVICE icon.
GEO 15 Service Manual - Rel. 0 2 0 6 -2016