Coretec VCX-7401, Installation And Operating Instructions Manual

Page: 30 / 38

Default: 63
Example Command:
SATURATION 75
(increases color saturation from default)
TINT [n]
Adjusts color tint. The acceptable range is from –128 to 127.
Default: 0
Example Command:
TINT 10
(adjusts tint)
SAP Settings
The encoder is capable of multicasting SAP (Session Announcement Protocol RFC-
2974) packets with SDP (Session Description Protocol RFC-2327) content. There are a
number of parameter settings for configuring SAP. They are presented in this section.
The user should refer to the referenced RFCs to understand the significance of the
SAP/SDP parameter settings.
SAP
This command is used to enable or disable the SAP multicast. ON or OFF are the
permitted parameters.
Default: OFF
Example:
SAP ON
SAPINFO
This command is used to set the SDP (RFC-2327) info information. The
parameter is an ASCII string with a limitation of 62 characters.
Default: Core Tec VCX2400e
Example: SAPINFO Intersection of 1st and main
SAPINTERVAL
This command sets the interval between SAP packet transmissions. The
parameter is the number of milliseconds between transmits.
Default: 5000 ms (5 seconds)
Example: SAPINTERVAL 10000 ms (10 seconds)
SAPIP
This command s ets the IP address of the destination host for SAP packets. This
address is a multicast address defined in RFC-2974. It is unlikely that the user will need
to change this setting.
Default: 224.2.127.254
SAPNAME
30