1.3 Dial Switch Setup
Before installing the camera, the dome address, communication protocol and baud rate
should be confirmed. The default dome address, protocol and baud rate are 1, PELCO-D
and 2400 respectively.If you want to change, please power off the camera firstly and open
the camera cover to find the dial switches. The steps are followings:
Chapter 1 Introduction
2
●
For example: If you want to set dome address as “73", 73=1+8+64 means the button
1, 4, 7 should be set to “ON” status.
●
For example: If you want to set dome address as “5", 5=1+4 means the button 1, 3
should be set to “ON” status.
The ID address adopts binary
system coding:
n”
stands
for
the
button
number in SW2.
n-1
2
. which “
For example: the button 1 is set to “ON” status , while others are set to
1-1
“OFF” status, the address is 2 =1; the button 2 is set to “ON” status , while others are set
2-1
to “OFF” status, the address is 2 =2, and so on. Please refer to the below chart.
①
SW2 is used to set dome address. The buttons from 1 to 8 are equivalent to bit 0
～
bit 7
respectively; “ON” status of each button means 1, while “OFF” means 0.
NOTE:
Please set the dial switch correctly according to the binary system,
here we do not list one by one.
Button
Dome ID
128
64
32
16
8
4
2
1
1
2
3
4
5
6
7
8
Summary of Contents for CD7622-TVI-IR
Page 31: ...450011000583 A0 ...
