MODEL CS 208 v2
MAY 2003
AN 2D v2 - INPUT CHANNEL OPTIONS
30
Limiter Threshold
Threshold - normally set at +4 PPM, with the input fader a ‘0’.
Limiter Threshold Adjustment
(no external test equipment required.)
*
Assign oscillator to C,D only (or Aux only).
*
Switch input channel to Line in.
*
Switch out C,D from the mix bus on input channel & turn off Aux sends.
*
Connect C,D or Aux outs to the input channel (short mic cable).
*
Pan L or R for A,B busses & switch off limiter.
*
Set input fader at ‘0’.
*
Adjust level for full scale on A/B meters (A/B masters at max.).
*
Turn on limiter, adjust threshold for +4 PPM (or desired level).
Limiter LED Adjustment
The limiter LED in not affected by the limiter threshold adjustment.
However to change its turn on point the procedure above may be used.
The turn on point is normally 2-3 dB higher than the limiter threshold so that it’s not too sensitive to peaks of
short duration.
The trimmer (RP2) is on board A (see layouts). An extender board is available, however access is also possible by
removing 1 or 2 input modules.
Clockwise = lower turn on point.
Summary of Contents for CS 208 V2
