MODEL CS 208 v2
Left Section
1. CH:
Channel Power (down = on) Do not switch during recording.
2. PH/DYN/T:
Phantom power, no mic power, T (AB) power
(Phantom power is normally 48 v, see layout A to change to 12 v).
3. ø:
Phase (audio only). ø = normal phase, REV = reverse phase
4. Mic/Line:
Microphone or line level in.
5. Pad:
Attenuator to reduce either mic or line input levels.
6. HP 1:
High pass filter, pre-transformer.
7. HP 2:
High pass filter, post transformer & preAmps.
8. EQ:
Equalizer bypass. Affects HF, MF & LF filters, not HP filters.
9-12. A,B,C,D:
Channel to mix bus assigns. L(left), R(right) indicate monitor & pan
pot assignment.
13. LIM+LED:
The limiter is a symmetrical peak detecting type & is completely out
of circuit when switched off. Threshold: See (15). Attack & release
times are preset internally (see layout A to change). The LED
indicates limiter action.
14. PFL/AFL+LED:
Pre fade listen or After fade listen (post fader). The switch is not
momentary, the LED serves as warning that PFL or AFL is
selected.
15. Thres.
Limiter threshold. Clockwise = lower threshold.
16.O/L
Near overload indicator.
INPUT MODULE
MAY 2003
1
Summary of Contents for CS 208 V2
