•
Box SN
and
Drive SN
display the respective serial numbers for the event.
•
Drive Manufacturer
displays vendor information.
•
Message
gives an event description.
2.
Click
Refresh
to update the log or click
Close
to close the log.
Table 18
-
LED States
LED
On (Solid)
Off
Blinking
Flashing
Drive
1
Drive is
rebuilding
Drive is not being
accessed
Bad drive or disconnected
from host
Normal read/write
activity
Drive
2
Drive is
rebuilding
Drive is not being
accessed
Bad drive or disconnected
from host
Normal read/write
activity
System Power ON
Power OFF or corrupted
firmware
N/A
N/A
Alarm
Error
No error
N/A
N/A
Note: The easiest way to tell the difference between a blinking LED and a flashing
LED is that flashing stops when the read/write activity is finished and blinking does
not stop. The blink rate is slower, but the difference in speed is more difficult to
detect visually.
Troubleshooting
Table 19
-
Troubleshooting Suggestions
Problem
Resolution
LEDs
Confirm power at the outlet, verify power connection, and try an alternate
power cable.
System LED is off.
Install new firmware.
Evaluate the drive for failure and replace if needed.
Drive 1 or Drive 2 LED is
blinking.
See
HBA connection
below.
Drive 1 or Drive 2 LED is
on continuously.
A
SAFE
volume is rebuilding on the drive.
Fan
System fan is not running.
Power supply fan is not
Confirm the outlet is powered, verify power connections, and try an alternate
power cable.
