ALSPA PROFIBUS Field Bus Coupler
3. Installation
(09/06)
Technical Manual
Page 3-1
3. Installation
3.1
PCB Handling Information
An earthed anti-static wristband must be worn when handling the
PROFIBUS
board.
3.1.1
Receipt of Equipment on Site
Where the PROFIBUS board is shipped separate to the general
drive assembly, the equipment should be carefully unpacked and
inspected for any signs of damage. Check the complete
consignment against the packing slip for any loss in transit. If any
damage or loss has occurred, contact your local supplier
immediately giving the following details:
-
A list of damaged or missing items.
-
A description of the damage.
-
The order number or packing slip details.
3.1.2 Storage
If the equipment delivered to site is not to be installed immediately:
-
Re-pack it in its original packing material.
-
Store it in a clean dry atmosphere, preferably at room
temperature. See section 2.1.9.
3.2
Configuration Details for Drive Modules
There are two types of PROFIBUS board. The MVS3007-4001
board is identifiable by the daughter board mounted on pillars and
the presence of the 8 way Dual in Line (DiL) switch, S3. See Figure
3-1 MVS3007-4001 PROFIBUS Board and Figure 3-2 MVS3007-
4001 PROFIBUS Layout. The MVS3007-4002 board has neither
the daughter board nor switch S3 fitted.
When fitted in a drive, the MVS3007-4001 and MVS3007-4002
PROFIBUS boards are differentiated by the position of the 9 pin D
connector. The connector is in the middle of the MVS3007-4001
board, whereas on the MVS3007-4002 board the connector is close
to the LED indicators.
