Commander SE User Guide
40
Issue Number 5
The settings for parameter 05 are explained fully on the following pages.
Parameter 5 set to A1.A2
Local voltage (A1) or remote current (A2) speed reference inputs
Figure 6.3 Terminal connections
If the Run Forward and Run Reverse terminals are both closed, the Drive will
stop under the selected ramp and stopping modes.
Jog speed reference (parameter 15)
If jog speed is selected during normal running, the motor will accelerate or
decelerate to the jog speed at the normal acceleration ramp (parameter 03) or
deceleration ramp (parameter 04) and then the jog acceleration and
deceleration ramps (0.2 seconds) will be selected. Once jog has been
selected use the Run Forward or Run Reverse terminals to jog.
Input
Source
Terminal 12
Terminal 13
Enable
Run Forward
Run Reverse
Motor Action
A1
open
open
closed
closed
open
Run Forward
A1
open
open
closed
open
closed
Run Reverse
A2
closed
open
closed
closed
open
Run Forward
A2
closed
open
closed
open
closed
Run Reverse
NOTE
Terminal 12
Terminal 13
Enable
Run Forward
Run Reverse
Motor Action
open or closed
closed
closed
closed
open
Jog Forward
open or closed
closed
closed
open
closed
Jog Reverse
NOTE
