EN
W415-1283 / F / 04.30.18
43
finishing
Phazer
TM
logs and glowing embers, exclusive to Continental™, provide a
unique and realistic glowing effect that is different in every installation. During
the initial use of the appliance, log colours may vary. During the initial use
of the appliance, the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
Blocked burner ports can cause an incorrect flame pattern.
1. Remove the main safety barriers and doors, see "main safety barrier
removal / installation" and "main door removal / installation" sections for
removal instructions.
2. Line the hole in the bottom of log #1 with the screw and spacer in the
log support. Then place onto the screw and spacer located in the corner
of the burner, on the right side. Place a pin into the center of log #1
(Fig.
1)
.
3. Place log #2 onto the pin located in the log #1, it should rest in the
middle of the left side log support as shown in Figure 2. Place one pin
into the middle of log #2
(Fig. 2)
.
4. Place log #3 onto the pin located in log #2 and let it rest on log #2, as
shown in Figure 3 and in the left side view below. Place another pin into
log #2
(Fig. 3)
.
5. Place log #4 onto the pin located in log #2 and let it rest on log #2
(Fig.
4)
and in the left side view.
6. Place log #5 onto the screw and spacer located in the left side log
support and let it rest on the burner
(Fig. 5)
.
LEFT SIDE VIEW
1
2
3
4
5
6
7
8
10
Fig. 5
Fig. 1
SCREW / SPACER
Fig. 3
PIN
Fig. 2
PIN
11
10.11 log placement
Fig. 4
SCREW / SPACER
!
WARNING
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
48.1
The individual logs can be easily identified by the numbers cast on the underside of each log.
note:
The pilot is located on the right end in these instructions.
note:
Ensure log #5 does not cover any burner ports.
note:
