Contec IPC-BX/M560, User Manual

Page: 74 / 90

Functions of Components
IPC-BX/M560(PCW)
63
* 013Bh: Event output control
PO2
M
rsv*
R/W RESET: 10X00X00b
PI2M PI0M
rsv*
WDT
M
WDT
E
NMIE
D6 D5 D4 D3 D2 D1 D0 D7
Figure 5.16. Event Output Control Port (013Bh)
NMIE : Enables PI0 NMIs.
0 : Enables NMIs by the PI0/NMI(15) signal in the RAS
connector.
1 : Disables NMIs by the PI0/NMI(15) signal in the RAS
connector.
PI0M : PI0/NMI(15) input mode
0 : Sets the PI0/NMI(15) signal in the RAS connector to
PI0 (general-purpose input).
1 : Sets the PI0/NMI(15) signal in the RAS connector to
an NMI interrupt input.
PI2M : PI2/RST(14) input mode
0 : Sets the PI2/RST(14) signal in the RAS connector to
PI2 (general-purpose input).
1 : Sets the PI2/RST(14) signal in the RAS connector to
a RESET input.
PO2M : PO2/WDT(12) output mode
0: Sets the PO2/WDT(12) signal in the RAS connector to
PO2 (general-purpose output).
1: Sets the PO2/WDT(12) signal in the RAS connector to
an alarm-out output.
• If general-purpose output P2 is set in the alarm output mode, the
ALARM LED on the front panel of the main unit comes on.
Note!
Do not change the setting for any " rsv" bit because it is system
reserved.