Setup
BUF-PCI(PC), BUF-PCI(98)
28
Installing for Windows 98
Install the software for Windows 98 following these steps.
(1) Install the BUS-PCI(PCI) board hardware.
(2) Install the BUF-PCI driver software.
(3) Run the BUF-PCI self-diagnostic program.
Installing the BUS-PCI(PCI) board hardware
Before the BUS-PCI(PCI) board can be used under Windows 98, the
OS must recognize the I/O addresses and interrupt level (IRQ) to be
used for the BUS-PCI(PCI) board. Use the appropriate procedure to
install the BUS-PCI(PCI) board.
(1) Turn the personal computer ON to start up Windows 98.
(2) Windows 98 will come up with the [New Hardware] detection
dialog box. In the [Add New Hardware Wizard] that appears next,
check that "Multimedia Device" has been listed, then select
[Next>].
(3) In the next dialog box, select a radio button of [Search for the best
driver for your device. (Recommended).], then select [Next>].
(4) In the next dialog box, select two check box both of [Floppy disk
drives] and [Specify Location:], then enter the drive name: \Win95
in the [Location] field. Insert BUF-PCI Driver Install Disk 1 into
the disk drive, then select [Next>].
(5) In the [Windows driver file search for the device] dialog box,
check that "CONTEC Co., Ltd.-BUF-PCI(PCI)" and
"BUF_PI0.INF" in the [Location of driver] has been listed, then
select [Next>].
(6) In the next dialog box, check the "Windows has finished installing
the software that your new hardware device requires." message,
then select [Finish]. This completes installation of the BUS-
PCI(PCI) board.
After finishing installing the board, confirm the assigned resources.
The "Checking resources" part of this section explains you how to
do it.
