22
Save and exit engineer’s mode
Move to the next setup area
feedback. The Ducking Adjustment setting determines how much volume
variation the ducking can utilise between the two sides. Sound quality
can be compromised if an excessive amount of ducking is used.
• Hearing Loop Drive Adjustment
– Increase or decrease the strength of
the installed hearing loop’s magnetic field. The drive level should be
adjusted so that red LED 8 on Vol Out is illuminated only when there are
peaks in the speech volume (see diagram on following page).
Entering Engineer’s Mode
Before entering engineer’s mode, cycle the power. To do this either:
•
Switch the power off at the wall socket and back on again,
or,
•
Remove the power connector and re-insert it
To enter engineer’s mode, simultaneously press and press and quickly
release the following buttons within 20 seconds of cycling the power:
• Settings button
• Volume In increase button
• Volume Out increase button
The on/off and settings buttons in engineer’s mode operate as follows:
