3-34
Chapter 3: Software Installation - Windows 95
Echo
User's Manual, ver. 0.00
2.
Choose an IRQ for your Echo. It is possible to have the even
ports on one IRQ and the odd ports on a different IRQ, but
we recommend having all ports on one IRQ. Good choices of
IRQ's are 5, 10, 11, 12 and 15. The two serial ports that
come with your system usually use IRQ 4, 3 and LPT1 is
usually IRQ 7. Please refer to the Table showing typical IRQ
usage in
Chapter 2: Hardware Installation
. For our
example we will choose IRQ 10.
Figure 15
shows the
example IRQ setting. Please refer to
Figures 1, 2,
or
3
in
Chapter 1: Introduction
for the location of the jumper block
J1.
Figure 15:
Windows 95: IRQ settings
A
B
3
4
5
7 10 11 12 15
IRQ
J1
Note
All Echo ports interrupt on Channel A, IRQ 10.
Technical Tip
You can run under DOS, the DOS programs
porttest.exe
and
portfind.exe
,
to verify your settings and assure you have no
hardware conflicts. You will find these programs on the
DFlex
DOS Driver
diskette (p/n: DISK306)
3.
You can now install the Echo in your system and start up
Windows 95. Once Windows-95 has started, go to the
MY
COMPUTER
icon and double click.
4.
Now click on
CONTROL PANEL
and then click on
ADD NEW
HARDWARE
. The
ADD NEW HARDWARE WIZARD
will appear.
Click
NEXT
. It will prompt you for
AUTODETECTION
, select
NO
and click
NEXT
. A list of hardware devices will appear,
select
PORTS(COM & LPT)
and click
NEXT
. Now select
COMMUNICATIONS PORT
and click
NEXT
.