Step 10
Install the first tread [I] by
placing over the tabs on
the side panels as shown.
While holding part [I]
down on the side panels
tap inward with a rubber
mallet until locked in
place.
IF YOU HAVE THE CONFER CURVE STEP
AND DO NOT HAVE THE ADD-ON
CONTINUE WITH STEPS 10-18.
IF YOU HAVE THE CONFER CURVE STEP
WITH THE OPTIONAL ADD-ON SKIP STEPS
11-18 AND GO TO STEP 19.
STOP!
Step 8
Determine which side will
be facing up on the front
foot pads [H], # 1 for a flat
bottom pool or # 2 for
a pool with slight taper
towards thecenter, install
both parts [H].
Step 6
Installing the Foot Pads
[H]: If swimming pool has
a flat bottom, all four foot
pads [H] will be installed
with the #1 facing up. If swimming pool has a slight taper
towards the center, the back foot pads will be installed
with #1 facing up and the front foot pads with #2 facing up.
#1
#2
Step 4
Install the rest of the curved
risers [C] by flexing the side
panels [A] outward enough
to insert part [C] tabs into
part [A]. Tap into place with
rubber mallet.
Step 5
Tilt the step
backwards to expose
all four of the rounded
tabs on the bottom
edges. Apply a little
liquid soap on the
[4] tabs to help with
installing foot pads.
Rotate
90°
Step 7
The two back foot pads [H]
will always be installed with
#1 facing up. Place part [H]
over the rounded tab, strike
with a rubber mallet until
seated onto the rounded
tab. Repeat to install
second part [H].
Step 3
While holding lower
tabs in part [A] align
the top tabs then tap
down with a rubber
mallet until flush.
Each side panel [A] requires 20
lbs of sand split between the two
fill holes. Sand is needed as ballast
to hold step down in the water.
Remove the caps installed in the
panels then using a funnel fill the
lower hole completely to the top
with sand. Shake the panel to help
settle the sand, lower hole must
be completely filled. Pour what’s
left from the 20 lbs into the upper
fill hole. Using provided caps, plug
both the lower and upper fill
holes. Repeat procedure to
fill the second part [A].
Step 9
STOP!
Pour
sand into
funnel.
SAND
Step 11
Repeat step 10 to install
second tread [I].
Step 12
To install the lower
handrail posts [E] first
locate the openings on
part [A] just below the
second tread marked
with #3. Next insert the
tabs on part [E] all the
way into the openings
then tap down with a
rubber mallet until seat-
ed. Repeat to install the
other part [E].
3
