CONFER CURVE STEP ADD-ON INSTRUCTIONS (Cont’d.)
Install the second tread
[I] onto the base step
Step 33
Install the long hand-
rail post [L] into the
opening on the add-on
panel [J] marked with #3 next to it. Push
the tab all the way in then tap down to
lock in place.
Step 34
Install the small flex
riser [R]
Step 35
Place the small curved
tread [S] over the hand-
rail post and attach the same as in step 32.
Step 36
Install the lower and
upper handrail posts [E]
to the left side panel by
repeating steps 12
and 13.
Step 37
Repeat step 14 to
install the top tread
[1-3].
Step 38
Place both deck
connectors [F] over the
upper handrail posts and slide down.
Check to make sure the side marked [this
side down] is facing downward.
Step 39
Place handrails [G]
over the top of handrail
posts and push down
to lock in place.
Step 40
7
Step 38 (Cont.)
With your Curve step fully assembled locate the [4]
recessed screw locations on the top tread. At each of
these locations [4 total] drill a 1/8” pilot hole completely
through the tread and into the step sidewall below.
Step 38 (Cont.)
Using a Phillips head screwdriver install one of the
#10 x 1-1/4” stainless screws at each location [4 total].
[HAND TIGHTEN ONLY]
TO COMPLETE STEP AND
PLACE IN POOL FOLLOW
STEPS 17 THROUGH 18 ON
PAGE 4 OF THE INSTRUCTIONS.
NO ADDITIONAL SCREWS
NEEDED FOR ADD-ON
CURVED TREADS.
WARNING!
Using a corded
drill near pool
may result in
electrocution.
