background image

 CP-CURVE STEP-IG  REV. 1-19

Safe Use

To reduce the risk of drowning, entrapment, falls, 
paralysis, or other serious injury or death: 

Use step system properly.

•  No diving or jumping from steps

 - shallow water; risk of paralysis or death.

•  ONE PERSON ON THE LADDER/STAIR AT A TIME. 

Weight limit -  400 lbs maximum. 

Exceeding maximum weight may cause the 

stairs to fail.

Secure stairs when not in use. 

When pool is not in use, make sure gate is 

closed and locked. 

Watch children at all times

 when they are in or around water to help prevent drowning.

BE SURE AND SAFE. 

The manufacturer 

IS NOT

 responsible for improper

 

assembly Installation and use.

WEEKLY STEP MAINTENANCE

 -  

To prevent algae growth it’s important 
to have properly balanced pool water. 
Consult with your pool professional 
for  proper choice of pool sanitizer.  In 
addition, at least once a week, while 
inside swimming pool, use a garden 
hose with a good high pressure nozzle 
to spray under and behind the step 
system. The force of the water will 
flush out any dirt, allowing the pool 
filter to remove it from the water.

8

Printed in USA

S

MADE IN THE USA

CONFER PLASTICS INC. FIVE YEAR WARRANTY

Confer Plastics Inc. warrants their swimming pool ladders and steps to be free from defects in 

workmanship for five years from date of purchase.

DO NOT RETURN DEFECTIVE PART TO DEALER

E-MAIL CONFER PLASTICS AT:   [email protected]  

A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,  

PROOF OF PURCHASE AND YOUR CONTACT INFORMATION. 

INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT:  716-694-3102 

OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU  

WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND  

THE SHIPPING/HANDLING CHARGES.

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.

Confer Plastics Inc.

97 Witmer Road

North Tonawanda, N.Y. 14120-2421

97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 800-635-3213
FAX 716-694-3102
www.conferladders.com

WINTERIZING / REMOVING STEP FROM POOL

PLAN AHEAD - PEOPLE WILL HAVE TO GET IN THE POOL TO MOVE OR REMOVE THE STEP.
When winterizing your pool, if you decide to leave the pool step in the pool be sure to detach the step from the pool deck 
and move the step towards the center of the pool and away from the pool wall. Remove any outside steps or ladders from 
the pool area to eliminate access to the pool.
If you decide to remove your pool step from the pool:  

To remove the step start by disconnecting both of the mounting brackets from the deck. From inside the pool position one 
person on each side of the step, grip the bottom of the side panels and carefully lift the step high enough to start tilting 
back on the pool deck. 

DO NOT LIFT STEP BY HANDRAILS, POSTS OR TOP TREAD. THE HANDRAILS, POSTS AND 

TOP TREAD WILL NOT SUPPORT THE WEIGHT OF THE POOL STEP AND MAY DETACH OR BREAK, RESULTING IN A 
FALL OR INJURY.

With most of the weight off the step, continue lifting and tilting back on to deck. Leave the step lying on it back edges for 
a couple of hours to drain the water. Once the water is drained stand the step up.
With the water drained your Confer step can be stored outside during the off season, it is not necessary to store inside.

 Pool step will be heavy and must be lifted from within the pool. Have additional help if you   
 move the step or choose to remove it from swimming pool. Do not attempt to do this by 

yourself - 2-3 people are required to move pool step safely. DO NOT lift pool step by handrails or handrail posts - they 
may detach, possibly resulting in a fall. 

Remove any outside steps or ladders from the pool area to eliminate access to the pool.

Summary of Contents for CCX-IG









Reviews: