Operating Instructions
750 W 27 V pickup
CQF 04/2 + Interface M12
BAL9100-0145a-EN
www.conductix.com
translated document
Page 37 of 40
13
Disassembly and Re-use
WARNING!
Danger of injury due to improper disassembly!
If it is necessary to exchange a device due to damage or to install it in another place, verify that no
damage will occur during disassembly.
-
When installing at a different location, observe the installation and commissioning instructions
described.
-
All electric work has to be carried out by qualified staff (IEC 364 respectively, CENELEC HD 384 or
DIN VDE 0100 and IEC 664 or DIN VDE 0110 and national safety rules).
-
Qualified staff, according to the safety regulations, are persons that are familiar with the installation,
assembly, commissioning and operation of the energy supply system and that have the appropriate
qualifications.
13.1
Notes on disassembly
1.
Disconnect the IPT
®
system from the mains voltage.
2.
Make sure the system cannot be powered up again accidentally.
3.
After disconnecting from the mains voltage, wait at least 5 minutes for internally stored energy to discharge.
4.
Remove the device.
5.
Return components for reuse or dispose of them separately in
recycling
13.2
Recycling
CAUTION!
Environmental damage due to improper disposal!
The device contains components that must be disposed of separately.
→
Ensure that the device is recycled properly after is no longer in use.
→
If necessary, dispose of the materials separately (cables, circuit boards, heat sinks, etc.).
